Jump to content

melvicaus

Members
  • Posts

    8
  • Joined

  • Last visited

About melvicaus

  • Birthday 27/02/1941

melvicaus's Achievements

Member

Member (1/3)

  1. I'd like to fly from Melbourne to Yackandandah for a family reunion. Can anyone suggest a landing strip closer than Wangaratta aerodrome?
  2. Greg, Thank you so much. I have just run the same route on Simulator and you were right on the money. Wonderful Jurgen
  3. Mike, I updated the firmware. Still have the same problem. I entered a route YPEF - YMNG - YSHT- YTOC. The first leg is 38.7 nm. on the map page, DIST NEXT is shown as 38.7nm. ETE is shown at 22.00. NEXT WPT is MNG. When I get to YMNG, DIST NEXT has run down to 0 nm and ETE to 0.00. Message says "next course 009". After I have overflown YMNG, both DIST NEXT and ETE commence running UP and not resetting and then running down from YSHT. The only way to run down from YSHT is from Active Route page > menu> next route waypoint > enter. Is there no automatic way for this to happen?
  4. Can anybody help with a problem I have with my GPS. I create a new route by entering waypoints. Then I activate the route. The screen window displays the active route with the arrow symbol showing that I am navigating from the first to the second waypoint. On the map page, the Dist Next shows the distance remaining to reach the next waypoint and runs down to zero as that waypoint is reached. The GPS then shows the next waypoint, but the Dist Next increases showing distance from my take off point and not distance from next waypoint. Is there a setting that I have entered incorrectly?
×
×
  • Create New...