Jump to content

rhtrudder

Members
  • Posts

    429
  • Joined

  • Last visited

About rhtrudder

  • Birthday 27/07/1953

Information

  • Aircraft
    Sabre
  • Location
    Tongala
  • Country
    Australia

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

rhtrudder's Achievements

Well-known member

Well-known member (3/3)

  1. Maybe end up going through the week
  2. Hi anyone flown the VFR track through Nowra , I’ll be heading south, wondering if it’s easy enough, Greg
  3. At around 4500 revs my engine definitely has increased vibration ,below 4000 and above 5000 it’s good , I think I come across this in another thread, it’s fitted with a O2 sensor so I know the mixture is correct, prop been balanced, could this be harmonics , has anyone else come across this
  4. Noticed a soft compression one one cylinder so ran through a leak down test sat the gauge on 80 , three read 77psi but the sick one was down to 75 psi , I guess not a lot of difference, could hear a faint bubble in the oil tank , engine has 1850 hrs up, would a set of rings an a hone fix this , back in my 2 stroke days rebored to get everything round , engine is a 914
  5. Dumb question, but how do you access the track logs from the skyecho
  6. If there is a DPDT switch could that be the problem, not easy to get to the trim motor
  7. Sorry should have said it’s on the elevator, I’ve got manual flaps
  8. Trouble is the thing only stops working in the air, would be better if it didn’t work at all, it has 5 wires, I think 3 are for the indicator
  9. Having intermittent problem with my up trim , down works always but up stops now and then, don’t think it’s in the switch, pulled apart and looks ok, can sometimes get it to work if I touch the down trim , not sure how to the thing is wired, looked up a wiring diagram and looks like it earths out back at the switch but I can’t figure out how it reverses the polarity , would there be another relay or controller to do that, there is a birds nest of wiring behind the panel so not easy to trace
  10. Okay, you’ve talked me out of it, thanks
  11. It took a few rinses to get rid of the frothy water, the plastic looks as solid as my other petrol containers
  12. Okay, they had roundup or glyphosate in them , probably just as corrosive as petrol maybe
  13. Can anyone see a problem using plastic 20 lt ag chemical containers to store petrol in , have got plenty to choose from
  14. Have replaced the throttle cables with good quality ones, smooth operation, carby balance looks good, at 5000 revs the butterflies would be nearly fully open , engine revs to redline on takeoff, has a inflight adjustable, if I run it at 5300 it’s good but when I pull it back to 5000 it’s very noticeable , I thought if the prop was out it would vibrate through the whole range, I’ll get it checked anyway
×
×
  • Create New...