It was developed from the company's C-119 Flying Boxcar, and was unique in the unconventional use of removable cargo pods that were attached below the fuselage, instead of possessing an internal cargo compartment. The XC-120 Packplane began as a C-119B fuselage (48-330, c/n 10312) with a point just below the flight deck cut off to create the space for the detachable cargo pod.. The wings were angled upwards between the engines and the fuselage, raising the fuselage by several feet and giving the plane an inverted gull-wing appearance. Smaller diameter "twinned" wheels were installed forward of each of the main landing gear struts to serve as nosewheels, while the main struts were extended backwards. All four landing gear units, in matching "nose" and "main" sets, could be raised and lowered in a scissorlike fashion to lower the aircraft and facilitate the removal of a planned variety of wheeled pods which would be attached below the fuselage for the transport of cargo. The goal was to allow cargo to be preloaded into the pods; it was claimed that such an arrangement would speed up loading and unloading cargo. Production aircraft were to be designated C-128. Only one aicraft was built, Though the aircraft was tested extensively and made numerous airshow appearances in the early 1950s the project went no further. It was tested by the Air Proving Ground Command at Eglin Air Force Base, Florida, in 1951, before the project was abandoned in 1952. The prototype was eventually scrapped. The heading photo is a composite of two photos of the one aircraft.
